Hall-effect current sensor IC is optimised for 3.3 V operation at high temperatures
The device consists of a precision, low-offset linear Hall sensor circuit with a copper conduction path located near the die. Applied current flowing through this copper conduction path generates a magnetic field which is sensed by the integrated Hall IC and converted into a proportional voltage.
Device accuracy is optimised through the close proximity of the magnetic signal to the Hall transducer. A precise, proportional voltage is provided by the low-offset, chopper-stabilised BiCMOS Hall IC, which is programmed for accuracy at the factory.
High-level immunity to current conductor dV/dt and stray electric fields, offered by Allegro proprietary integrated shield technology, guarantees low ripple at the output and low-offset drift in high-side high-voltage applications. The output of the device has a positive slope when an increasing current flows through the primary copper conduction path used for current sensing.
The internal resistance of this conductive path is typically 100 microhms, providing low power loss. The thickness of the copper conductor allows for 200 A continuous current sensing applications and survival to much higher transient currents.
The terminals of the conductive path are electrically isolated from the sensor leads, allowing the ACS759 family of sensors to be used in applications requiring electrical isolation without the use of opto-isolators or other costly isolation techniques. The device is fully calibrated prior to shipment from the factory.
Typical applications include motor control, load detection and management, power supply and DC/DC converter control, inverter control, and overcurrent fault detection.
The ACS759 sensor IC is lead (Pb) free. All leads are plated with 100% matt tin, and there is no lead inside the package. The heavy-gauge leadframe is made of oxygen-free copper. The device is available in a small 5-pin CB package with easy mounting capability.
Please click here to download a copy of the data sheet: http://www.allegromicro.com/en/Products/Current-Sensor-ICs/Fifty-To-Two-Hundred-Amp-Integrated-Conductor-Sensor-ICs/ACS759.aspx
- Programmable Hall effect current sensor
- Camera sensor for ADAS applications offers high dynamic range
- MEMS sensor measures acceleration, yaw rate in six axes
- "No car will be an island"
- Riedon targets low cost current sensing applications with low ohmic value resistors
- Automotive applications drive magnetic sensor demand
- Safety IC has pressure sensor inside
- Driver chip controls stepper motors at full current
- Proximity and gesture recognition sensors spread to automotive dashboards
- 10-channel automotive LED driver IC operates over the 4.5 to 36V range
- Starter Current Module, DC/DC converter stabilize power in Mild Hybrids
- Automotive synchronous buck regulator
- Next generation wheel balancing transducer is fully watertight
- Transmissive optical sensors target encoder applications
- Power supply IC combines automotive qualification with very low quiescent current
- Jaguar docks on to Intel for next-gen infotainment systems
- Interface integrates e-vehicles into smart grid
- Kvaser proposes backward-compatible, high-bandwidth CAN version
- Women demand different connectivity functions in the car
- Smart cars offer "once in a generation chance" to UK industry, experts say
- Get your digital copy of EETimes Europe
- EV market is much more than passenger cars - and it's booming
- Emergency Steer Assistant can avoid collisions
- Faurecia, Magneti Marelli jointly integrate tablets and smartphones into cars
- MOST 150 Star topology interconnects driver assistant systems
- Field test fathoms out economic potential for electric mobility
- Researchers significantly improve lithium-air batteries
- Volvo starts large test with robot cars on public roads
- Automotive drives new processor architectures
- Haptic feedback touchpad contributes to driving safety